Replacing The Lamp - Optoma EP1690 User Manual

Appendices
Warning :
Lamp compartment is
hot! Allow 30 minutes
to cool down before
changing lamp!
Warning :
To reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
English 3

Replacing the Lamp

The projector keeps track of the lamp usage. It will show you
a warning message
When you see this message, change the lamp as soon as pos-
sible. Make sure the projector has cooled down for at least 30
minutes before changing the lamp.
1
2
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the Standby/
ON button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove 1 screw from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module. 
To replace the lamp module, reverse the previous steps.
http://www.pureglare.com.au
3
4