McCulloch M175H38RB Manual page 9

• Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
• Press the vinyl bindings onto the sides of front bagger
tube.
RE TAIN ER
SPRING
VINYL
BINDING
RE TAIN ER
SPRING
NOTE: For tractors with an electric dump system, refer to
the kit instructions for more assembly procedures.
MANUAL BAGGER DUMPING ONLY:
• Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin 10 x 44mm and secure
with retainer clip.
• Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in
order to use the handle to clear the chute in the event it
has become clogged.
DUMP HANDLE
TUBE
CLEVIS PIN
3/8 X 1-3/4
RE TAIN ER CLIP
CAP
ASSEMBLY
SPREADER BARS
(Inside of bag)
VINYL
BINDING
Fig. 9
Fig. 10
BAGGER ADJUSTMENT (See Fig. 11 & 12)
For proper bag function and appearance, it may be nec es sary
to adjust the bagger assembly. There should be 1/4" (6 mm)
- 3/8" (9 mm) gap between the bagger top and fender and
the bagger top surface should be even with the top surface
of the fender. To adjust bagger position:
HORIZONTAL ADJUSTMENT
• Slightly loosen the nuts securing the bagger RH and LH
hor i zon tal adjustment brackets. Loosen only enough
so the brackets keep their position, but allow them to
be moved.
• Move the brackets the amount forward or back ward
you wish the bag assembly to move. Retighten the
nuts securely.
VERTICAL ADJUSTMENT
• Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep
their position, but allow them to be moved.
• Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
• Reinstall the bagger as sem bly and check the bagger
to fender fit. If necessary, repeat the procedure until
proper fit is attained.
• After proper fit is attained, remove bagger from tractor
and install bagger latch to tractor back plate as shown.
Tighten securely.
• Install and carefully lower bagger to actuate latch.
HOR I ZON TAL
AD JUST MENT
BRACKET
VERTICAL
AD JUST MENT
BRACK ET
• Measure distance between bagger and latch as shown.
If distance is not 7/16" (10 mm) - 5/8" (16 mm) carefully
remove bagger and repeat vertical adjustment as
needed.
7/16" - 5/8"
(10MM - 16MM)
9
6MM (1/4") - 9MM (3/8")
TOP SURFACES
EVEN
02967
Fig. 11
BAGGER LATCH
Fig. 12