McCulloch M175H38RB Manual page 8

TO INSTALL BAGGER COM PO NENTS TO
TRAC TOR (See Figs. 4 - 7)
• Remove discharge chute from rear of tractor. Unhook
the two (2) straps and pull chute out and away from
tractor.
• Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
DISCHARGE
CHUTE
3/8 NUT
• Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
• Install bagger support plugs into top of support tube.
BAGGER
SUPPORT
PLUG
SUP PORT TUBE
3/8 NUT
FLAT WASHER
• Install the two upper support brack ets through the back
plate and to the chas sis using two each 3/8 x 19mm
hex bolts and 3/8 locknuts from parts bag. Tight en
securely.
• Assemble both support brackets to the outside of the
bagger support tube using two each 3/8 x 63,5mm hex
bolts, 13/32" I.D. flat washers and 3/8 locknuts from
parts bag. Tight en securely.
• Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
ASSEMBLY
FLAT WASHER
Fig. 4
BOLT
Fig. 5
3/8 LOCK NUT
SUPPORT BRACKET
10,3MM (13/32)
FLAT WASHER
3/8 X 63,5MM HEX BOLT
3/8 X 19MM HEX BOLT
SUPPORT BRACKET
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to float with
the mower deck when moving on uneven terrain.
TO ASSEMBLE BAGGER (See Figs. 8 - 10)
• Unfold bag by pivoting front bagger tube all the way
forward and pressing the bottom vinyl binding onto the
tube.
FRONT BAGGER TUBE
8
Fig. 6
DISCHARGE CHUTE
HOOK
BACKPLATE
Fig. 7
VINYL
BINDING
Fig. 8
SLOT