Peavey PV8 USB Operating Manual
Compact mixers
Hide thumbs
Also See for PV8 USB:
- Specification (5 pages) ,
- Operating manual (72 pages) ,
- Operating manual (48 pages)
Related Manuals for Peavey PV8 USB
Summary of Contents for Peavey PV8 USB
- Page 1 8 and PV 8 USB ® ® Compact Mixers Operating Manual www.peavey.com...
- Page 2 ATTENTION: Afin de réduire le risque de choc électrique, ne pas enlever le couvercle. Il ne se trouve à l’intérieur aucune pièce pouvant être reparée par l’utilisateur. Confiez I’entretien et la réparation de l’appareil à un réparateur Peavey agréé. AVIS: Dans le but de reduire les risques d’incendie ou de decharge electrique, cet appareil ne doit pas etre expose a la pluie ou a l’humidite et aucun objet rempli de liquide, tel qu’un vase, ne doit...
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. - Page 4 ENGLISH 8, PV 8 USB ® ® Compact Mixers Congratulations on purchasing the Peavey PV 8 or PV 8 USB Compact Mixer. The PV 8 is a studio-quality mixing console ® ® ® designed to meet diverse needs while occupying a small space. These are the perfect consoles for small venue performances or home recording environments.
-
Page 5: Front Panel
Front Panel Gain This control establishes the nominal operating level for the channel. The input gain can be adjusted over a wide range to compensate for soft voices or very loud drums. To maximize the signal-to-noise ratio, the gain should be set to the proper level, with the channel Fader (12) set to 0. If the clip LED comes on and remains lit, try reducing the gain. - Page 6 Front Panel Phantom Power LED This LED lights when the Phantom Power Switch (11) has been engaged. Phantom Power Switch Applies +48 VDC Voltage to the input XLR connectors to power microphones requiring phantom power. If phantom power is used, do not connect unbalanced dynamic microphones or other devices to the XLR inputs that cannot handle this Voltage.
-
Page 7: Rear Panel
Front Panel Headphone Output The Headphone Output is a 1⁄4 " TRS (tip= left; ring = right; sleeve = ground). The signal sent to this output is normally the Left/Right mix. When the Tape to Control Room switch is engaged, the tape input signal is added to the Left/Right mix and can be monitored in the headphones. - Page 8 Front Panel Stereo (1⁄4") Inputs These 1⁄4" unbalanced inputs work as a stereo line input using both jacks or as a mono input if the connection is made to the Left/Mono input only. The A/B input selector must be in the "A" position for these jacks to be active.
- Page 9 Use to connect the included power supply. Be sure the power supply is connected to the PV®8 before connecting to a power source. Use 15 VDC, 0.5A adapter only. Note: Replace only with Peavey part number 30901986 for Domestic or 30902780 for Export. Power Switch Depressing the power switch supplies power to the unit.
- Page 10 ® 8 Block Diagram...
- Page 11 8 Series Specifications ® Inputs Input Levels Function Input Z Input Gain Bal/ Connector (ohms min) Setting Min** Nominal* Unbal Microphone 2.2k Max Gain -83 dBu -59 dBu -41 dBu XLR Pin 1 Gnd (150 ohms) (63 dB) Pin 2 (+) Pin 3 (-1) Min Gain -30 dBu...
- Page 12 8 Specifications ® Frequency Response Mic Input to Left/Right Output 14 Hz to 25 kHz +0 dB/-1 dB Total Harmonic Distortion <0.01% 20 Hz to 20 kHz Mic to Left/Right Output (10 Hz to 80 kHz BW) <0.005% Typical (22 Hz to 22 kHz BW) <0.0007% Mic Pre-amp Distortion Hum and Noise Output...
- Page 13 Features and specifications subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian, MS 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com © 2007...