Table of Contents
Advertisement
DMD50 Universal Satellite Modem
Insert timeslots is performed automatically and is transparent to the user. In PCM-30C Mode,
the user may not select timeslot 16 as a Drop or Insert Timeslot.
H.1.3.3
PCM-31
The PCM-31 Mode of Operation supports an E1 Interface with no Multiframe Alignment
(MFAS) or Channel Associated Signaling (CAS). The user may independently program n
timeslots to drop and n timeslots to insert where n = 1, 2, 3, 4, 5, 6, 8, 10, 12, 15, 16, 20, 24, or
30. Because there is no implied ABCD signaling, the user is free to select timeslot 16 as a Drop
or Insert Timeslot.
H.1.3.4
PCM-31C
The PCM-31C Mode of Operation supports an E1 Interface with no Multiframe Alignment
(MFAS) or Channel Associated Signaling (CAS). In addition, the Drop Function verifies the
received terrestrial CRC checksum and the Insert Function calculates the required CRC
checksum. The user may independently program 'n' timeslots to drop and 'n' timeslots to insert
where 'n' = 1, 2, 3, 4, 5, 6, 8, 10, 12, 15, 16, 20, 24, or 30. Because there is no implied ABCD
signaling, the user is free to select timeslot 16 as a Drop or Insert Timeslot.
H.1.3.5
T1-D4/T1-D4-S
The T1-D4 Mode of Operation supports a T1 Interface with 12 frames per multiframe. The user
may independently program n timeslots to drop and n timeslots to insert where n = 1, 2, 3, 4, 5, 6,
8, 10, 12, 15, 16, 20, 24, or 30. Robbed Bit Signaling (RBS) is handled without any need for
operator intervention and is transparent to the user.
H.1.3.6
T1-ESF/T1-ESF-S
The T1-ESF Mode of Operation supports a T1 Interface with 24 frames per multiframe. The
CRC-6 checksum is automatically checked by the Drop Function and generated by the Insert
Function and placed in the appropriate F-bit positions in the terrestrial multiframe. The user may
independently program n timeslots to drop, and n timeslots to insert, where n = 1, 2, 3, 4, 5, 6, 8,
10, 12, 15, 16, 20, 24, or 30. Robbed Bit Signaling (RBS) is handled without any need for
operator intervention and is transparent to the user.
H.1.4 Multidestinational Systems
Because the Drop and Insert Functions are completely independent, so multi-destinational
communications are easily supported.. Figure H-6 illustrates a Multi-destinational System with
one Hub site and three remote sites. At the Hub site, thirty channels are being transmitted to all
three remote sites and a fractional set of channels is being received from each remote site. At the
other end of the link, each remote site is transmitting a fractional E1 to the Hub site as well as
receiving all 30 channels from the Hub site. It also identifies those channels intended for it, and
inserts them into the terrestrial data stream.
MN-DMD50– Revision 3
Drop and Insert (D&I)
H–5
Advertisement
Table of Contents
Troubleshooting
