Belkin Wireless G User Manual page 13

Installing and Setting up the Card Installing and Setting up the Card
2.7
Carefully screw the antenna onto
the threaded connector on the
Card. Turn the antenna until it is
vertical and pointing up.
2.8
Replace the computer's cover.
Now that the Card is installed, you
can reconnect the power cord and
turn the computer back on.
2.9
After restarting, you will be
prompted to select your country
location. Please select the country
you are located in, then click "OK".
2.10
The Found New Hardware Wizard
will appear. (This may take 15–20
seconds.) Select "Install the
software automatically" and then
click "Next".
2.11
You might see a screen similar to
this one. This DOES NOT mean
there is a problem. Our software
has been fully tested and is
compatible with this operating
system. Select "Continue Anyway"
and follow the on-screen instructions.
2.12
The Wizard will now install your
software.
10 10