NordicTrack Cable Cross 831.6002.1 User Manual page 6

2. Remove the Shroud (not shown) from the back of
the weight system. (Note: The cover on the
Frame [1] is shown removed for clarity; the
cover cannot be removed.) Remove the four
indicated M6 x 64mm Bolts (59) from the Frame.
Remove the Weight Guides (16).
Lubricate the inside of the welded tubes on the
Top Weight (15) with grease.
See the inset drawing. Position the Arms (19,
20) as shown (see ADJUSTING THE ARMS on
page 7). Attach the two ends of the Cable (33)
together with two Cable Clips (10).
Orient the two Weight Bumpers (4) so the wide
ends are over the indicated holes in the bottom of
the Frame (1). Insert the two included dowels (not
shown) into the Weight Bumpers and the Frame.
Slide the five 20-pound Weights (13) and the nine
10-pound Weights (14) onto the dowels. Note:
Make sure that the Weights are stacked in
order so that the 10-pound Weight marked "1
5" is on top, and the 20-pound Weight marked
"15 100" is on the bottom.
Remove a dowel (not shown) from the stack of
Weights (13, 14). Reinsert a Weight Guide (16)
into the Frame (1) and the hole in the Weights.
Repeat with the other Weight Guide. Secure
the Weight Guides to the Frame with the four M6
x 64mm Bolts (59), the four M6 Washers (81), the
four Weight Guide Spacers (5), and the four M6
Nylon Locknuts (60).
Disconnect the ends of the Cable (33) and lower
the Top Weight (15), so that the weight selector is
inserted into the middle hole in the stack of
Weights (13, 14).
Make sure the Cable Traps (78) are oriented as
shown in the CABLE DIAGRAM on page 9.
Replace the Shroud (not shown).
3. Attach a Handle (9) to a Cable Eye (37) with a
Cable Clip (10). Attach the other Handle to the
other Cable Eye in the same manner.
4. Make sure that all parts have been properly
tightened. The use of the remaining parts will
be explained in ADJUSTMENTS beginning on
the following page.
2
60
15
Welded
Tube
Weight Selector
20
33
10
3
37
10
9
6
16
81
5
59
81
5
14
81
13
5
4
60
1
19
59
81