Advertisement
Siren
Mount the siren in the engine compartment away from moving or heat-producing components. If possible, mount the siren on the
opposite side of the exhaust manifold. The siren must not be accessible or visible from outside or under the vehicle. Point the siren
downward to avoid water collection and enhance sound projection.
1. Mount the siren using all three sheet metal screws supplied.
2. Connect the siren's BLACK wire to the control unit YELLOW wire.
3. Connect the siren's RED wire to the control unit RED wire.
Op tional Horn Connection
If you choose not to use the standard siren, the yellow wire can be programmed as a horn output and can be connected to the
vehicle's horn. This output is negative and can provide up to 2 amps.
RPM Monitoring
See the RPM Monitoring Wiring section in this binder. This connection is only necessary if you do not want BlackJax 4 to start it's
countdown if the door is opened at high RPM's.
Connect the RED wire to the 5amp fuseholder.
Connect the RED/WHITE wire to the 20amp fuseholder.
Attach the two fuseholders to the battery positive cable clamp.
Attach the BLACK wire to the battery negative cable clamp.
Note: This MAN DA TORY pro gram ming step must be com pleted if the tach is con nected for Black Jax to op er ate
prop erly.
1. Drive the vehicle to a nearby open area and allow the engine to warm-up until the RPMs drop to the normal idle speed.
2. With the engine still running, place the transmission in PARK (or NEUTRAL if the vehicle has a manual transmission).
3. Enter installer-programming mode (turn the ignition ON, enter the factory preset valet code by pressing the
and the unmarked button once, then press and hold the
seconds and three chirps once installer-programming mode has been accessed).
4. Press the unmarked button of the PlainView 2 Switch once. After a three-second pause, the system will sound one chirp to
confirm column one selection (see the Installer-Programmable Features section on page 20).
5. Press the
button of the PlainView 2 Switch five times (you will hear a chirp each time you press the button) to select row five.
After a two-second pause, you will hear two chirps to confirm idle RPM has been set (if you hear just one chirp, check the
connection of the BLACK/GRAY wire, then repeats steps 1 - 5).
6. Turn the ignition OFF.
1. Start the car.
2. Open and close the door.
3. Press/release the brake.
Wait 25 sec onds. You should hear 5 chirps. If not, go to step 1 below.
n
The brake lights will be gin flash ing. If not, go to step 2 below.
n
n
30 sec onds later, the si ren should sound and car's en gine should slowly die. If not, go to step 3 below.
n
Once the car is dis abled, en ter the valet code to dis arm. If the sys tem does not dis arm, go to step 4 below.
Step 1 - Black Jax not ini tial iz ing
1. Check the door trig ger con nec tion and po lar ity.
2. Check the brake trig ger.
BlackJax/199
Engine Compartment Connections
Final Wiring Connections
RPM Programming Procedure
button for 20 seconds - you'll hear one chirp after the first three
System Check/Troubleshooting
button two times
3
Advertisement
