Cadillac 2012 SRX Owner's Manual page 423

10. Now start the vehicle with the
good battery and run the
engine for a while.
11. Try to start the vehicle that had
the dead battery. If it will not
start after a few tries, it
probably needs service.
Notice: If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct
order, making sure that the
cables do not touch each other
or other metal.
Jumper Cable Removal
A. Heavy, Unpainted Metal
Engine Part or Remote
Negative ( ) Terminal
B. Good Battery or Remote
Positive (+) and Remote
Negative ( ) Terminals
C. Dead Battery or Remote
Positive (+) Terminal
Vehicle Care
To disconnect the jumper cables
from both vehicles, do the following:
1. Disconnect the black
negative ( ) cable from the
vehicle that had the dead
battery.
2. Disconnect the black
negative ( ) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+)
cable from the vehicle with the
good battery.
4. Disconnect the red positive (+)
cable from the other vehicle.
5. Close the access panel on the
battery cover, if applicable.
10-91