Step 1. Monitor Installation & Setup Controls And Connection Options - Zenith P50W28A Installation And Operating Manual

Monitor Controls
Power Standby Indicator
Illuminates red in standby mode,
Illuminates green when the
Monitor is turned on
Connection Options
R AUDIO L
( ) R ( )
AUDIO
EXTERNAL SPEAKER (8Ω) AC INPUT
INPUT
1 2
1. EXTERNAL SPEAKER (8 ohm output)
Connect to optional external speaker(s).
* For further information, refer to 'Speaker & Speaker Stand'
manual.
2. POWER CORD SOCKET
This Monitor operates on an AC power. The voltage is indi-
cated on the Specifications page. Never attempt to operate
the Monitor on DC power.
3. AUDIO/VIDEO INPUT JACKS
Connect audio/video out from external equipment to these
jacks.
S-VIDEO INPUTS (S-VIDEO)
Connect video out from an S-VIDEO VCR to the S-VIDEO
input.
4. COMPONENT(DVD/DTV INPUT)/AUDIO INPUT JACKS
6
Front Panel Controls
VOL. MENU INPUT SELECT
INPUT SELECT Button
MENU Button
VOLUME ( F , G ) Buttons
D , E Buttons
Back Connection Panel
Y P P
B R
(MONO)
R AUDIO
VIDEO COMPONENT AUDIO
S-VIDEO
INPUT (DVD/DTV INPUT) INPUT
3 4
Remote Control Sensor
ON/ OFF
L
REMOTE RGB1 OUTPUT AUDIO
CONTROL
LOCK CONTROL
(PC/DTV OUTPUT) INPUT
5 6
5. CONTROL LOCK Switch
REMOTE CONTROL
When "CONTROL LOCK" is set "ON", Monitor is operated
by the external control device.
6. RGB1 OUTPUT(PC/DTV OUTPUT) JACKS
You can watch the RGB1 signal on another monitor, con-
nect RGB1 OUTPUT (PC/DTV OUTPUT) to another moni-
tor's PC input port.
7. AUDIO INPUT/RGB1 INPUT (PC/DTV INPUT)/
RGB2 INPUT (DIGITAL RGB INPUT) JACKS
Connect the monitor output connector from a PC to the
appropriate input port.
8. RS-232C INPUT (CONTROL/SERVICE) PORT
Connect to the RS-232C port on a PC.
ON/OFF
Main Power Button
( ) L
RGB1 INPUT RGB2 INPUT RS-232C INPUT
EXTERNAL SPEAKER
(PC/DTV INPUT) (DIGITAL RGB INPUT) (CONTROL/SERVICE)
7 8 1
( )