Controls And Connection Options - Zenith P50W38 Installation And Operating Manual

Controls
Controls
- This is a simplified representation of front panel.
Here shown may be somewhat different from your monitor.
Main Power Button
Connection Options
Connection Options
- Connection panels shown may be somewhat different from your monitor.
( ) ( ) ( ) ( )
R L
RS-232C INPUT
EXTERNAL SPEAKER
(CONTROL/SERVICE)
1 2
1. EXTERNAL SPEAKER (8 ohm output)
Connect to optional external speaker(s).
* For further information, refer to 'Speaker & Speaker
Stand' manual.
2. RS-232C INPUT (CONTROL/SERVICE) PORT
Connect to the RS-232C port on a PC.
3. DVI (Digital Visual Interface) INPUT/
RGB INPUT/AUDIO INPUT JACKS
Connect the monitor output connector from a PC to the
appropriate input port.
4. RGB OUTPUT PORT
You can watch the RGB signal on another monitor, connect
RGB OUTPUT to another monitor's PC input port.
Front Panel Controls
Front Panel Controls
ON/OFF
Remote Control Sensor
Back Connection Panel
Back Connection Panel
DVI INPUT RGB INPUT AUDIO INPUT RGB OUTPUT
3
INPUT SELECT Button
MENU Button
R AUDIO L
REMOTE
AUDIO INPUT
CONTROL
4 5
5. REMOTE CONTROL
Connect your wired remote control to the remote control
port on the Monitor.
6. COMPONENT INPUT/AUDIO INPUT JACKS
Connect a component video/audio device to these jacks.
7. S-VIDEO INPUTS
Connect S-Video out from an S-VIDEO VCR to the S-VIDEO
input.
AUDIO/VIDEO INPUT JACKS
Connect audio/video out from external equipment to these
jacks.
8. POWER CORD SOCKET
This Monitor operates on an AC power. The voltage is indi-
cated on the Specifications page. Never attempt to operate
the Monitor on DC power.
E D
, Buttons
VOLUME ( F , G ) Buttons
Power Standby Indicator
Illuminates red in standby mode,
Illuminates green when the
Monitor is turned on
Y P P
B R
COMPONENT INPUT S-VIDEO VIDEO INPUT
6 7
Introduction
R L (MONO)
AUDIO
AUDIO INPUT AC INPUT
8
Owner's Manual 7