Table of Contents
Advertisement
8. Loosen the bleeder bolt on top of
the engine. Tighten it again
when coolant comes out in a
steady stream with no bubbles.
9. Refill the radiator to the base of
the filler neck. Put the cap on the
radiator, only tighten it to the
first stop. Start the engine and
let it run until it warms up (the
radiator cooling fan comes on at
least twice).
BLEEDER
BOLT
RESERVE TANK
10. Turn off the engine. Check the
level in the radiator, add coolant
if needed. Install the radiator cap,
tighten it fully.
11. Fill the reserve tank to the MAX
mark. Install the reserve tank
cap.
Cooling System, Windshield Washers
Windshield Washers
FLOAT
Check the level in the windshield
washer reservoir at least monthly
during normal usage. In bad
weather, when you use the washers
often, check the level every time
you stop for fuel.
CONTINUED
Maintenance
Advertisement
Chapters
Table of Contents
