Hdstb Setup; Monitor Out Setup - Zenith Z44SZ80 Installation And Operating Manual

Installation

HDSTB Setup

HDSTB Setup
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV's COMPONENT (Y, P
HDMI2 jack for video connections, depending on your set-top box connec-
tor. Then, make the corresponding audio connections.
Note: HDMI(High Definition Multimedia Interface): Input that accepts uncom-
pressed digital signal and multi channel digital audio signal.
How to use
1. Turn on the digital set-top box. (Refer to the owner's manual for the digital
set-top box.)
2. Use TV/VIDEO on the Remote Control
Component 2, RGB-DTV, HDMI1/DVI or HDMI2 source.

Monitor Out Setup

Monitor Out Setup
The TV has a special signal output capability which allows you to
hook up a second TV or monitor.
Connect the second TV or monitor to the TV's MONITOR OUTPUT.
See the Operating Manual of the second TV or monitor for further
details regarding that device's input settings.
Note
• Component, RGB-PC/RGB-DTV, HDMI1/DVI,HDMI2, DTV input
sources cannot be used for Monitor out.
14 DLP Projection TV
, P ) INPUT, RGB, HDMI1/DVI or
B R
to select Component 1,
Signal Component 1/2 RGB-DTV,HDMI1/DVI,HDMI2
480i Yes
480p Yes
720p Yes
1080i Yes
RGB INPUT
S-VIDEO
PC/DTV
(XGA
/480p
/720p
/1080i)
MONITOR
INPUT2 INPUT1
OUT
RGB/DVI INPUT
(L)
AUDIO
(R)
MONO
VARIABLE
AUDIO OUT
(L)
AUDIO
(R)
No
Yes
Yes
Yes
S-VIDEO
IN
(R) AUDIO (L) VIDEO