Table of Contents
Advertisement
System installation
16
Siemens AG
2.
If required, remove the knockout for surface cable entry (see figure below).
Abb. 5
Surface cable entry
3.
Insert the plastic anchors into the holes.
4.
Remove the torx screws on the dome cover.
5.
Connect the individual wires to the appropriate terminals for power, RS485
and alarm-in.
6.
Attach the dome unit to the ceiling using the torx screws and O-rings
provided.
7.
Manually adjust focus and zoom.
8.
Attach the dome cover to the dome base using the torx screws.
9.
Cover the screw heads with the plastic caps provided.
Optional: The mounting base CVAA-JB01 is provided if the cable run on the
surface needs to be made vandal-resistant.
Abb. 6
Mounting base
04.2011
Advertisement
Table of Contents
