Sharp MX-M260 Online Manual page 26

2 TROUBLESHOOTING
Printing does not take place
Check the machine
■ Power switch on?
Turn the power switch on. (See "POWER ON AND OFF" in
the operation manual)
■ Is the machine online?
When the ON LINE indicator next to the [PRINT] key on the
operation panel is lit, the machine is online and ready to
print. If the ON LINE indicator is off, press the [PRINT] key
and then touch the [ONLINE] key. (When [ONLINE] is
highlighted, the machine is online.)
COPY
ON LINE
PRINT
DATA
DATA
SCAN
LINE
FAX
DATA
■ Has an error occurred such as a paper misfeed,
staple jam in the finisher, out of paper, or out of
toner?
When one of the above errors occurs, a message will appear
in the touch panel to alert you.
Follow the instructions in the message to clear the error.
Printing will automatically resume when the error is cleared.
For information on handling errors, see "TROUBLESHOOTING"
in the operation manual.
CO NT E N TS
■ Copy job being performed?
Wait until copying is finished. You can also select the key of
the job that you wish to print in the job status screen and then
touch the [PRIORITY] key. Copying will be interrupted and
the selected job printed.
☞
■ Is the "I/O TIMEOUT" setting too short?
Set a longer time for "I/O TIMEOUT" in the system settings
(administrator) (see "I/O TIMEOUT" in the "SYSTEM
SETTINGS (ADMINISTRATOR)" in the operation manual).
■ Has a Notice Page (NP-001) been printed?
ONLINE
OFFLINE
If a print job containing more data than can be held in the
BYPASS TRAY
print memory is sent to the machine, the print data has not
been printed completely.
Disable the ROPM function on the "Configuration" tab of the
printer driver setup screen. If you need to use the ROPM
function, divide the pages of the print data into two or more
print jobs.
The memory allocated to the printer function can be changed
in the system setting (administrator) "MEMORY FOR
PRINTER".
Giving priority to a print job
(part 3)
26