Thermostat Removal; Remote Thermostat Wiring At Water Heater - Maytag HRE21250PC User Manual

Instructions for Installation (cont'd)
THERMOSTAT REMOVAL (cont'd)
10. Carefully disconnect wiring harness terminal connector
from back of thermostat.
BACK OF
THERMOSTAT
11. Remove the wall plate from the water heater by unscrewing
the two mounting screws. The wall plate will be installed at
the selected location in Steps 28 and 29.
MOUNTING
SCREWS
12. Loosen each screw in the terminal connector and remove the
wire ends. The terminal connector will be installed at the
selected remote location in Step 31.
SCREW
SLOTS
THERMOSTAT
CABLE
TERMINAL
CONNECTOR
WALL PLATE
WIRING
HARNESS
TERMINAL
CONNECTOR
13. Press the end of the thermostat cable back into the insulating
bushing. No other connections will be made to this end of
the cable.
WIRING
HARNESS
14. Close and latch outer door.

REMOTE THERMOSTAT WIRING AT WATER HEATER

15. Remove mounting screw and right junction box cover. Also
lift up and remove black plug on left junction box cover.
Discard plug.
BLACK
PLUG
LEFT JUNCTION
BOX COVER
18
INSULATING
BUSHING
RIGHT JUNCTION
BOX COVER