Removing The Memory Module; Installing The Memory Module - Lenovo ThinkCentre 7061 Hardware Installation And Replacement Manual

This section provides instructions on how to replace a memory module.
Note: Your computer has support for four memory modules.
1. Remove the computer cover. See "Removing the cover" on page 11.
2. Locate the memory connectors. See "Identifying parts on the system board" on
3. Remove the memory module being replaced by opening the retaining clips as
Figure 31. Removing the memory module
4. Position the replacement memory module over the memory connector. Make
Figure 32. Installing the memory module
5. Go to Chapter 4, "Completing the parts replacement," on page 45.
34
Hardware Installation and Replacement Guide
Note: For this procedure, it helps to lay the computer on its side.
page 9.
shown.
sure the notch 1 on the memory module aligns correctly with the connector
key 2 on the system board. Push the memory module straight down into the
connector until the retaining clips close.