Installing Pci Adapters; Opening The Retainer Clips; Installing The Memory Module - Lenovo ThinkCentre 7061 Hardware Installation And Replacement Manual

v Use 512 MB, 1.0 GB, or 2.0 GB memory modules in any combination up to a
Note: Only DDR2 SDRAM DIMMs can be used.
To install a memory module:
1. Remove the computer cover. See "Removing the cover" on page 11.
2. Locate the memory connectors. See "Identifying parts on the system board" on
3. Open the retaining clips as shown.
Figure 7. Opening the retainer clips
4. Position the new memory module over the memory connector. Make sure the
Figure 8. Installing the memory module
5. Go to Chapter 4, "Completing the parts replacement," on page 45.

Installing PCI adapters

This section provides information and instructions for installing PCI adapters. Your
computer has two expansion connectors for PCI adapters, one for a PCI Express
x16 graphics adapter, and one for a PCI Express x1 adapter.
14
Hardware Installation and Replacement Guide
maximum of 8.0 GB.
Note: For this procedure, it helps to lay the computer on its side.
page 9.
notch 1 on the memory module aligns correctly with the connector key 2
on the system board. Push the memory module straight down into the
connector until the retaining clips close.