Operating Instructions - Electrohome EAAC302 User Manual

OPERATING INSTRUCTIONS

INSTALLING THE BATTERY
1. Using a small Phillips Head screwdriver, loosen the screw on the battery panel on
the bottom of the unit.
2. Remove the battery compartment panel.
3. Remove/properly dispose of depleted battery and replace with new, 3V, CR2032
Flat Lithium battery.
4. Close the battery compartment and tighten the screw into place to secure battery
panel.
• Batteries must be installed by an adult.
• Use only the recommended size and type of battery specified.
• Please be sure to follow the correct polarity when installing the battery
in the battery compartment. A reversed battery may cause damage to
the alarm clock.
• When not using the unit for a prolonged period of time, please remove
the battery to avoid possible damage caused by a leaking battery.
DAYLIGHT SAVING TIME (DST) / SUMMER TIME
Daylight Saving Time/Summer Time is automatically preset.
• Daylight saving time begins at: 2:00 AM on the second Sunday of March.
• Standard time begins at: 2:00 AM on the first Sunday of November.
Cancelling / reactivating Automatic DST/Summer Time
1. To CANCEL DST/Summer Time, press and hold the DST/HA button for 3 seconds
while the radio is OFF.
'OFF' will appear in the display to show that the Automatic DST/Summer Time
2.
adjustment is cancelled. The display will return to the clock.
- 12 -
OPERATING INSTRUCTIONS
3. To REACTIVATE DST/Summer Time, press and hold the DST/HA button for 3
seconds while the radio is OFF.
'ON' will appear in the display to show that the Automatic DST/Summer Time
4.
adjustment is reactivated. The display will return to the clock.
• The timing of Automatic DST/Summer Time employed by the unit (see above) is
subjected to variations by region and the law in each country/region. In such a
case, cancel the Automatic DST/Summer Time adjustment.
• If you live in a country/region that has not introduced Daylight Saving Time/
Summer Time, you must cancel Automatic DST/Summer Time adjustment before
using the unit.
SETTING THE DATE & TIME
To change the Date/Time, press and hold the
appear in the following order:
Year > Month > Day > 12/24 H > Hour > Minute
1. Press the button to DECREASE numbers or to toggle through settings
2. Press the button to INCREASE numbers or to toggle through the different
settings.
3. To confirm your selection, press the
• The PM indicator will light up when time is set to PM; no light for AM,
• Pressing the or buttons once, decreases/increases one number at a
time.
• Pressing and holding the or
numbers.
button. The settings below will
button once again.
quickly decreases/increases the
- 13 -