Table of Contents
Advertisement
Looking Inside ..... ..................................................
Shelves
Fresh Food Compartment
and Door
The shelves in this compartment are adjustable so the
interior of the fresh food compartment can be cus-
The fresh
food
compartment
is equipped
with
tomized for varying food storage needs.
adjustable, Spill-Catcher
TM
shelves. These shelves have
a spill retainer edge for easy clean up.
To remove a shelf:
In some models, these shelves have the slide out feature.
• completely unload the shelf
To slide out, simply grasp the front of the shelf and pull.
• slightly lift up the rear of the shelf
Gently push in to return the shelf to the original position.
• pull the shelf straight out
To lock a shelf into another position:
• tilt up the front edge of the shelf
• insert the hooks into the desired frame openings
• let the shelf settle into place
• be sure the shelf is securely locked at the rear before
reloading
I_k
WARNING
-- Never
to adjust this
of shelf when it is loaded with food.
attempt
type
Elevator
TM
Shelf
• Unload the shelf completely,
Certain models feature an Elevator
TM
shelf as one of the
fresh food compartment shelves.
The shelf can be
• Slide the shelf forward about two inches and manu-
adjusted up or down while loaded. To adjust this shelf,
ally move the two rear latches toward the shell
unfold the recessed crank handle so it is at a right angle
center.
to the shelf front. Crank to the right (clockwise) to raise
• While supporting the entire shelf and frame fron
the height of the shelf, and to the left (counterclockwise)
underneath, lift slightly and rotate the assembl_
to lower the height of the shelf,
approximately 30 ° to allow the rear mechanism tq
clear the vertical rear side rails.
The shelf has the slide out feature that allows easy
access to items stored toward the rear.
• The entire assembly can then be moved forward an<
To remove the Elevator ""shelf for occasional cleaning:
clear of the refrigerator compartment.
• Completely unload the shelf.
• To reinstall, reverse the removal procedure. Be sur_
the shelf is in a level position. When the sliding shel
• Grasp the shelf front and pull forward until it stops,
is pushed to the rear, it will reposition the rea
• Press the stops from below (both sides) upward and
latches to their correct operating position.
continue pulling the shelf forward, clear of the
frame.
• To reinstall, align the shelf to the frame and push it
all the way back. (There is no need to depress the
stops for reinstallation).
In ordinary use, the Elevator
TM
shelf with the frame
assembly does NOT require removal. Though unlikely,
and not recommended, the correct removal procedure is
as follows:
7
Advertisement
Table of Contents
