Table of Contents
Advertisement
Preparing the Printer for Operation
c. Adjust the two tractors on the forms tractor
assembly setting above and just behind the
paper shield by loosening the knurled knob
located behind each tractor. Slide tractors
horizontally
tp
the left or right as required to
line up with the paper width being used. Lock
tractors in this position by tightening the two
knurled knobs.
d. Open the covers on the tractors and fit the
holes in the edges of the paper over the
tractor pins as illustrated in Figure 2-6.
e. Close covers on the tractors and rotate platen
with the Platen Knob until the paper is over
the top of the external paper rack.
f.
Make sure the paper passes through the paper
out switch housing located to the left rear of
the paper pan so the paper out switch is
pressed by the paper. The paper out switch
senses when incoming paper is no longer at
the top of the bustle and causes an "Alarm"
condition. Approximately 16
11
(40.6 cm) of
paper remain available when the
11
Alarm"
occurs.
GEK-36150
PTR-3003
Figure 2-6. Fitting Paper Over Tractor Pins
PTH-4011
Figure 2-7. Pin Feed Paper Installed On Forms Tractor
2-4
Advertisement
Table of Contents
