GE GEK-36150 terminet 300 Operator's Manual page 16

Preparing the Printer for Operation
GEK-36150
PAPER
TUBE
Figure 2-2. Paper Tube
PKM-4009
i. To align the paper, move the Paper Release
Lever (Figure 2-1) to its forward (toward the
keyboard) position and align the left edge of
the paper with the vertical line on the paper
shield.
j. Move the Paper Release Lever to its most rear
(toward the bustle) position.
PIN FEED (300 PRINTER)
a. Align the paper supply container, holder, etc.,
behind the Printer. The paper supply should
be lower than the Printer's top surface.
b. Route the paper over the back of the Printer
toward the platen.
h. Lower the paper shield carefully. Do not let
the shield snap down.
c. Insert the paper under the platen and align
paper holes with the sprocket pins.
2-2
ANTI-CURL DEVICE
TENSION
LIMITER
PRESS HERE TO RELEASE
LOW PAPER SWITCH IF. IN LOCKED POSITION
PRESS DOWN HERE TO
"LOCK OUT
11
LOW PAPER SWITCH
---- --
- -
\
--
CD
PAPER OUT SWITCH IN LOCKED POSITION -DEFEATS ALARM - ENABLES OPERATION
@
PAPER OUT SWITCH IN FULL ROLL RANGE - ENABLES OPERATION
@
PAPER OUT SWITCH IN LOW PAPER POSITION
PKM-4010
Figure 2-3. Paper Installation - Friction Feed