Table of Contents
Advertisement
DSDA Digital Storage Disk Arrays
4
Unpacking and Installing the Hardware
NOTICE!
For more detailed information on the hardware installation please refer to the documentation
available on www.boschsecurity.com under Product Catalog > CCTV > Digital Recording and
Storage > Disk Arrays (Network Attached).
WARNING!
The storage system is heavy. Two people are required to lift a system.
CAUTION!
Only use the rail kit supplied with the system. Using a different rail kit can cause injury to you
or damage to your system.
1.
2.
3.
4.
5.
6.
Bosch Sicherheitssysteme GmbH
Unpack your system by opening the packing box and lifting the outer shipping box off the
pallet.
Install the appropriate rack mount for your installation and system using the Rack
Installation flyer in the rail kit box for reference.
Install the appropriate rack mount for any disk shelves that will be connected to the
system
With two people, lift the system into the rack or system cabinet, and secure it to the rack
uprights. The system weighs slightly over 30 kg (67 lb) and requires one person at the
end of the system to guide it into the rail ends.
For installation and wiring of additional disk shelves, see Section 7 Adding Storage,
page 20.
Connect the power cords, making sure that the power supplies are connected to
separate AC power sources. This ensures redundant power sources.
Make sure to set the power cable retention clips properly.
Ensure that power supply LEDs are lit.
Installation Guide
Unpacking and Installing the Hardware | en
9
- | V2 | 2009.11
Advertisement
Table of Contents
