Bosch DIVAR IP 6000 1U Installation Manual page 16

16 en | Chassis setup and maintenance
2.
3.
4.
1
2
5.
2014.01 | V2 | DOC
Remove the dummy drive from the carrier.
Install a new drive into the carrier with the printed circuit board side facing down so that
the mounting holes align with those in the carrier.
Secure the hard drive by tightening all 6 screws.
Drive carrier
SAS/SATA hard drive
Replace the drive carrier into the chassis bay. Make sure that the drive carrier handle is
completely closed.
Installation manual
DIVAR IP 6000 1U
Bosch Sicherheitssysteme GmbH