Camera1 - Panasonic AG-CPD20P Operating Instructions Manual

Administrator Setup

Camera1

Note:
If "Camera1" has not be set for any of Preset1, Preset2, and
Preset 3 on the Video Allocation screen in Administrator
setup, the Camera1 screen cannot be selected.
Page 1
Zoom Limit
Use this function to enter maximum zoom ratio.
Setting : ×22, ×220
AGC Level
Use this function to set the level of camera input gain control.
Setting : HIGH, OFF, LOW, MID
Init Backlight
Use this function to turn backlight compensation on or off
when the power is on.
Setting : OFF, ON, LAST
Init AE Shift
Use this function to adjust brightness when the power is on.
Setting : 0, -2, -1, +1, +2, LAST
Flip
Use this function to determine whether to vertically flip
camera video image or not.
Setting : OFF, ON
AutoZoom Magnification
Use this function to set the target zoom-in ratio.
Setting : ×10, ×15, ×22, ×1, ×2, ×3, ×4, ×5, ×7
AutoZoom Time
Use this function to set the zoom-in pause time.
Setting : 3 s, 5 s, 8 s
AutoZoom End Position
Use this function to set the zoom-end ratio for auto zoom.
Setting: x1, x2, x3, x4, x5, x7, x10, x15, x22, LAST
*
1 Applies the setting in effect when power was last turned off.
Unless power is turned off properly, the operating state may not
be saved correctly.
*
2 Automatically switches between ON and OFF.
(continued)
*
1
*
1
*
Page 2
Init Camera1 Rec LED
Use this function to turn the [REC] lamp on the camera
connected to the [CAMERA 1] connector on or off when the
power is on.
Setting : ON, LAST
Init IR Mode
Use this function to set the IR function when the power is on.
Setting : AUTO
IR Level
Use this function to set the IR function level during automatic
switching.
Setting : LOW, HIGH
IR Time
Use this function to set the IR function detection time during
automatic switching.
Setting : 30 s, 60 s, 300 s, 10 s
Auto Focus
Selects color camera focusing method when,
• [Init LPR Mode] is set to "DISABLE".
• [Init LPR Mode] is set to "ENABLE" and [LPR Mode] is set
to "PATROL".
• A recording trigger starts recording when [Init LPR Mode]
is set to "ENABLE" and [LPR Mode] is set to "LPR".
PRESET : When the zoom is 3x or below, the camera is
DISABLE : Focus is locked at about 40 m (130 feet) and
AUTO : Auto focus goes into operation when the
Init LPR Mode
Enables or disables the LPR function (license plate
recognition) when the recorder is turned on.
DISABLE : Color camera shutter speed changes to
1
ENABLE : Allows changes to be made to the officer
88
*
,OFF
1
* *
, OFF, ON, LAST
2 1
focused at about 15 m (50 feet). Subsequent
zooming will engage auto focus.
auto focus is not available.
zoom ratio is changed.
"AUTO". The zoom position for the camera at
power on returns to the position it had when
the power was last turned off.
[LPR Mode]. Values set in this mode will
persist through a power off and become
available at the next power on.