Check The Status [Status] - Panasonic TC0938450-015CE Operating Instructions Manual

15 Maintenance of the unit [Maintenance]

The name of the firmware to be used for the upgrade should be "model name (Use small letters. "WJ-" is
not required.)_xxxxx.img".* ("xxxxx" indicates the version of the firmware.)

Do not turn off the power of the unit during the upgrade process.

Do not perform any operation during upgrading and wait until it completes.

The following network settings will not be reset when upgrading the firmware after selecting "Reset the
settings to the default after completing the upgrade. (Except the network settings)".
On/Off for DHCP, IP address, subnet mask, default gateway, DNS, primary server address, secondary
server address, HTTP port, HTTPS port, connection protocol (HTTP/HTTPS), CRT key, server certificate,
UPnP setting, line speed, bandwidth control (bit rate), time & date

The viewer software used on each PC should be licensed individually. Refer to your dealer for the software
licensing.

15.3 Check the status [Status]

Click the [Status] tab of the "Maintenance" page. (section 6) The status of this unit can be checked on this
page.
[Viewnetcam.com]

Server: The URL of the "Viewnetcam.com" service server will be displayed.

Status: The registration status for the "Viewnetcam.com" will be displayed.

Personal(Unit) URL: The URL of the unit registered for "Viewnetcam.com" will be displayed.
[UPnP]

Port number(HTTP), Port number(HTTPS): The port number that is set for UPnP port forwarding will
be displayed.

Status: The port forwarding status will be displayed.

Router global address: The global address of router will be displayed.
[Self check]
The self check result of the hardware will be displayed.
Note

Refer to our website (http://panasonic.net/pss/security/support/info.html) for further information about the
contents of the displayed statuses (relating to the "Viewnetcam.com" service, the UPnP function, or the self
check).
94 Operating Instructions