Item
Preset Values
ERecording Settings (continued)
Enable speedup
On motion
On event
When to store
Always
images in
Never
database
Conditionally
F Datebase
Settings
G Motion
Detection
Settings
Motion Detection..
Motion Color..
Enables you to specify whether to execute recording with a higher maximum frame rate when
motion is detected or when an event occurs.
When [On event] is selected : Specify the starting and ending events in the [Start]
When the input is analog
Always
Never
Enables you to specify the recording conditions in recording control mode. If you have
selected [Conditionally], specify the following fields as well.
On motion
On event
Memo :
● For details on events, refer to [Camera Input/Output Port and Events] (A Page 95).
Note :
● If you have selected [Conditionally], the [ALARM] indicator on the front panel lights up
regardless of the recording status when the motion or event specified in [When to store
images in database] occurs. Press the [ALARM CLEAR] button to turn off the light of the
[ALARM] indicator.
( )seconds pre/post recordings on motion/event:
You can record images preceding and following a detected motion or event. Specify the time
interval to record in the number of seconds before and after the occurrence. (A Page 139)
Memo :
● Do not set to A0 secondsB.
● If Offline is selected in [Scheduler...], images will not be recorded.
● This setting has no impact on manual recording, emergency recording, and [EXT REC IN]
recording.
^
Enables you to specify the database settings. (A Page 110)
^
Enables you to specify the two parameters for motion detection, namely [Sensitivity] and
[Motion Sensitivity]. (A Page 104)
Enables you to specify the color to be used for highlighting detected motion.
Description
and [Stop] fields respectively.
The speedup recording frame rate uses the [Frame
Rate] in the [Speedup Settings] A item.
: Values of frame rate that can be set are 30, 15, 10, 7,
6, 5, 3, 2, and 1.
When set to 7, the rate is 7.5 frames per second.
: Select this check box to record images at all times.
: Do not perform recording in the recording control mode. Record
starts when the [REC/STOP] button is pressed.
: Select this check box to record all images for which motion has been
detected.
: Select this check box to record all images from the occurrence of an
event until the next event occurs regardless of motion. Specify the
starting and ending events in the [Start] and [Stop] fields
respectively.
57