2.4.1.2 Connectors for the DP-110-1x1
The connectors for the DP-110-1x1 are as follows:
computer connector
Note:
Inch-type hexagonal lock screws are installed in the RS-232 connector. If millimeter-type lock screws are
needed, use the millimeter-type lock screws of the accessory.
notch (one or more lines)
inch-type
2.4.1.3 Jumper setting
Set the jumpers on the DM-D stand as follows:
JP1
1-2
2-3
The jumpers are located as shown below:
JP1
JP2
2-4 Setup information
power supply unit connector
millimeter-type
JP2
1-2
For connecting both the TM printer and the DM-D stand.
(Default setting)
2-3
For using the DM-D stand a standalone.
(TM printer is not connected.)
display connector
extension cable connector
Perpose
printer connector
RS-232C connector
installation screw
. A
Rev