CHAPTER 1 Installation Overview
1.1 Setup Workflow
1.1.2 Work performed by the user
The user performs the following tasks in the order given.
No.
Work item
1.
Setup
2.
Installing the OS and
bundled software.
3.
Work after installation
4.
Configuring SNMP
and security
TABLE 1.1 Work performed by the user
Work tasks and description
- Initializing partition settings
Perform tasks such as setting partition names
and configuring partitions individually.
- Connecting and configuring the MMB
(operating environment)
- Setting up the connection environment for actual
operation.
Set up the MMB connection environment, such as
by setting the IP addresses for actual operation.
- Initializing MMB settings
Set the parameters for the entire MMB, such as the
user account names or system names.
- Setting various modes
Set modes as needed.
- Starting the system and confirming system startup
Start the system and confirm that it has started
normally.
- Saving setting information
Save the setting information for the MMB.
Install the operating system and bundled software.
Specify the monitoring method, and save the specified
information.
Configure SNMP and security.
3.1.2 Partition Settings
3.3.3Setting of Connection for Actual
operating Environment
3.3.10Registration of User Account
3.3.11Setting of System Name
3.3.12Setting of Date and Time
3.4.5Various mode settings
3.2System Startup
3.5Storage of the configuration
information
CHAPTER 4Installation of Operating
System and bundled software
CHAPTER 5Types of work
CHAPTER 7Power ON and OFF of the
partition
2
See
CA92344-0536-01