Panasonic KX-TAW848 Feature Manual page 178

1.16 S
[Explanation]
The following table explains the types of data logged by SMDR. Each description below refers to data
indicated above by the numbers in the parentheses.
Number in
the Pattern
(1)
(2)
(3)
(4)
(5)
178 Feature Manual
Data
Date Shows the date of the call.
Time Shows the end time of a call as hour/minute/AM or PM.
Ext (Extension) Shows the extension number, floating extension number, etc.,
which was engaged in the call.
Also shows the following codes:
Dxxx: Outgoing CO line call from a doorphone (xxx=doorphone
number) (→ 1.4.10 Doorphone Call)
*xxx: Verified call (xxx=verification code) (→ 1.19.1 Verification
Code Entry)
CO Shows the CO line number used for the call.
For patterns A and B, "00" will be shown for CO line numbers over
hundred.
Dial Number [CO Line Call]
Outgoing CO Line Call
Shows the dialed telephone number.
Digits shown are as follows:
0 through 9,
P: Pause
F: External Feature Access (EFA) signal
=: Host PBX Access code (→ 1.8.5 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialing
–: Transferred call
If the transfer destination extension enters additional digits, those
digits will be added after "–".
Incoming CO Line Call
Shows <I> + the caller's identification name/number.
[Outgoing Intercom Call]
Shows the dialed extension number followed by "EXT".
[Log-in/Log-out]
Shows the Log-in or Log-out status.
[Timed Reminder]
Shows the status of a timed reminder, either "Start", "No Answer",
or "Answer". (→ 1.17.3 Timed Reminder)
[Printing Message]
Shows the selected message. (→ 1.13.9 Printing Message)
[Sensor Call]
Shows calls from an external sensor as follows:
<I> S + sensor number. (→ 1.5.9 External Sensor)
Description
, #