Bosch Integral TM13 Operating Instructions Manual page 116

If in doubt, look it up
Dial
The displayed number is dialed.
Dial
Configuring the terminal adapter: Various settings facilitate the set up of
incoming and outgoing or just incoming calls.
Manual:
Asynchronous only. To support simple terminals. You can enter the call
number using the terminal keyboard.
AT command:
Asynchronous only. For automatic call control by means of AT commands
from the terminal.
Hotline 108:
For applications with dedicated lines. The target address is taken from the
telephone book of your telephone.
Incoming:
For automatic call setup. Only incoming calls are possible.
Direct dial:dest
Direct dialing: Dialing begins as soon as you press a destination key.
Direct dial:digit
Direct dialing: Dialing begins as soon as you press a digit key.
Disable charges
Deactivate charge recording for chargeable calls.
Disconnect
DTR: For call setup by your terminal. At the same time the function "DTR
contr." must be active. Otherwise, the call can only be cleared down by the
remote subscriber or by your telephone.
Display
If you disable the call number display, the number of the person you are
talking to is no longer displayed on your telephone. Moreover, the number
is not stored in the redial memory. Redisplay number: Select menu item
again.
Display
Tests the display. Each display remains on the screen for 5 seconds.
116
Menu items on the display "