Fujitsu ETERNUS DX200 S3 Configuration Manual page 85

Chapter 5 General Settings
5.5 LAN Cable Connection (for Operation Management)
To help with LAN cable management and prevent incorrect connections, attach labels to the LAN cables
•
and make a note of connection origins and destinations.
When connecting LAN cables, check the connector orientation and then firmly push it all the way in.
•
When disconnecting LAN cables, depress the tab, then pull out the connector.
This section uses a controller enclosure with two controllers as an example to explain the connection pro-
cedure. When one controller is installed, only Controller 0 (CM#0) has to be installed.
1
Connect the LAN cable to the ETERNUS DX Disk storage system.
Connect the LAN cable connectors to the MNT ports of the Controller 0 (CM#0) and Controller 1 (CM#1)
for the ETERNUS DX Disk storage system.
2
When the RMT port is used, connect the connector of the LAN cable to the RMT port of Controller 0
(CM#0) and Controller 1 (CM#1).
3
Connect the LAN cables of the MNT port to the network of the customer. If the RMT port is used for
remote support, connect the LAN cable of the RMT port to the network for remote support.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Do
When connecting the LAN cables, position them so that they will not obstruct
•
replacement of the power supply unit or controllers by the maintenance engi-
neer.
85
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0