Disk Partition Settings - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 8 SAN Connection Settings
8.2 Server Connection Setup
8.2.3

Disk Partition Settings

Set up disk partitions to use the specified LUNs for the ETERNUS DX Disk storage system.
The volumes are recognized as disks in order, starting from the volume that is set for LUN0.
For example, if LUN0 is recognized as Disk 1, LUN1 is recognized as Disk 2 and LUN2 as Disk 3.
Perform the settings as shown below.
Drive
F
G
H
I
J
K
L
M
*1: The capacity that is displayed in "( )" is the copy source capacity.
For the operation volume (Standard), perform
tings" (page 150).
For the volume for generation copy (Snap Data Volume), perform
153) in "8.2.3.2 Disk Settings" (page
8.2.3.1 Disk Recognition
The following procedure explains how to create a disk partition.
1
Open [Disk Management] via [Computer Management].
2
If the [Initialize Disk] screen appears, confirm that all the disks are selected and click the [OK] button.
Then proceed to
Select the checkbox for eight disks in this example.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
File system
that is to be LUN
created
NTFS 0
RAW 1
RAW 2
RAW 3
RAW 4
RAW 5
RAW 6
RAW 7
150).
Step 6.
Copyright 2014 FUJITSU LIMITED
Volume No. Volume name Type
0 main
1 sdv0
2 sdv1
3 sdv2
4 sdv3
5 sdv4
6 sdv5
7 sdv6
"■ Operation Disk Settings" (page 150)
"■ SnapOPC+ Destination Settings" (page
146
Capacity (*1)
Standard 1TB
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
SDV (1TB)
in "8.2.3.2 Disk Set-
P3AM-7652-02ENZ0