Ff2 2: T1 Trunks (Co) - Panasonic DBS-576 Technical Manual

FF2: Trunk Programming (T1 CO)
2.
Introduction

FF2 2: T1 Trunks (CO)

NOTE:
0
System
Configuration
FF1
System
Trunk Connection Type (CO/Network)
FF2
(all CPCs) - Version 1.0 or higher
Set whether the T1 channel is connected to the CO or to a private network.
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
Notes:
The remaining addresses in this T1 Trunks (CO) section will apply if the T1 trunk is set to 1=CO
FF5
(default) in the above address. If 2=Private Network is selected instead (for trunk connections between
Groups
2 or more switches), go to pg. 2-116.
The 1=CO (default) setting should be used for DID/DNIS trunks with E&M signaling, and the T1
Trunks (CO) addresses followed. (Set the Ring Type for these trunks as 1=DID or DNIS.)
FF6
TRS/ARS
Related Programming:
Ring Type/Destination for T1/CO trunks (pg. 2-107)
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 2-86
For T1 point-to-point private networks (trunk connections between 2 or
more switches), go to pg. 2-116 for T1 Trunks (E&M Tie).
If the carrier is providing DID/DNIS trunks with E&M signaling, use
these T1 Trunks (CO) settings - not the T1 E&M Tie settings.
FF2 2 BSSCC
BSSCC: T1 Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
DBS 576 (USA) issued 05/20/98
00 Hold (0-2) Hold
0=[no assignment]
1=CO (default)
2=Private Network
FF2 2 BSSCC 04 (0 thru 5) ...
Section 400-Programming
$
%3 %6 #0)*%
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B