Checking And Adjusting Throttle Control - Husqvarna Rider 15V2 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions

Checking and adjusting throttle control

Rider 15V2
The hydrostatic transmission cable (on the left
side) is adjusted in the following manner:
1. Remove the transmission cover.
2. Loosen the lock nut (1) on the ball joint.
3. Push the locking spring (2) forward far enough
for the socket (3) to be lifted from the ball on
the lever arm (4).
4. Depress the accelerator pedal completely and
use a screwdriver to move the lever arm (4)
forward as far as possible.
5. Adjust the socket (3) position on the connecting
rod (5) so that it fits exactly over the ball on the
lever arm. Fit the socket on the ball.
6. Lock the adjustment in place with the lock nut
(1) and push the locking spring (2) into place.
IMPORTANT INFORMATION
Check that the locking spring goes
through the hole in the spherical socket.
5
1
34
– English
2
3
4
www.mymowerparts.com
Rider Pro 15 and Pro 18
Adjust the hydrostatic wire (on the left-hand side)
as follows:
1. Remove the transmission cover.
2. Prise apart the lower ball joint, which is held
together by a spring clip.
3. Make sure the forward drive pedal is fully
depressed.
4. Raise the vertical arm as far as it will go and
check that the ball and socket that make up the
lower ball joint are level with each other.
5. If necessary, adjust the socket along the wire
so that it is perfectly level with the ball on the
lever.
6. Reconnect the ball joint.
7. Secure the ball joint with the spring clip.
8. Tighten the locking nut to lock the socket on the
wire.
IMPORTANT INFORMATION
Check that the locking spring goes
through the hole in the spherical socket.
Locking spring for the linkage.