Electrolux EN18WI30LS Use And Care Manual page 21

Preventing Damage from Freezing-2
For EN18WI30LS, EP18WI30LS
If the water heater will not be used for a long period of time,
drain the water.
Drain the water as follows:
CAUTION
Drain water into a bucket to prevent water damage.
1
Close the gas valve.
2
Turn off the power button.
3
Disconnect the electrical power supplied to the unit.
Do not touch with wet hands.
4
Close the water supply valve.
5
Fully open all hot water fixtures.
6
Turn the drain plug to the left to open, and then remove.
Allow a minimum of 10 minutes for water to drain out of the unit.
7
Check that the water is completely drained.
When completely drained, replace all drain plugs
and close the hot water fixtures.
To avoid burns, wait until the equipment cools
down before draining the water. The appliance
will remain hot after it is turned off.
High Temperature
Manual Draining
Fixture
Off
Drain Plugs
Each drain plug might not be visible if
insulation is installed around the piping.
19