CHAPTER 7 PCI Express card Hot Maintenance in Windows
7.3 NIC Hot Plugging
3. Confirm replaced PCI card by using Device Manager.
After replacement of target PCI card, open Device Manager, and confirm that the target device is
recognized correctly.
Note
As the follow, right-click target device in Device Manager, if there are [Enable] in displayed menu, check
[Enable].
(In case of [Disable], this work is not necessary)
7.2.3 About removal
Note
Windows does not support PCI card removal.
7.3
NIC Hot Plugging
For NIC hot plugging (replacement), you need to especially consider other matters in addition to the
procedure described in
This section describes NIC hot plugging combined with teaming.
7.3.1 Hot plugging a NIC incorporated into teaming
'7.2 Common Hot Plugging Procedure for PCI Express
173
cards'.
C122-E175-02EN