Panasonic WJ-SX550A Operating Instructions Manual page 109

5. Press the Stop (STOP) Switch to stop the Group
Sequence.
STOP
G-Seq 01 Stop
Monitor 16
6. Press the Forward Sequence (FORWARD SEQ)
Switch to continue a sequence that was previously
stopped by the Stop (STOP) Switch. The sequence
will continue in the forward direction from the step that
was selected at the time the Stop Switch was pressed.
FORWARD
SEQ
G-Seq 01
Monitor 16
7. Press the Backward Sequence (BACK SEQ) Switch to
continue a sequence that was previously stopped by
the Stop (STOP) Switch. The sequence will continue in
the reverse direction from the step that was selected
at the time the Stop Switch was pressed.
BACK
SEQ
G-Seq 01
Monitor 16
8. Press the Increment (INC + 1CAM) Switch to move a
sequence one step forward from the step that was
previously stopped by Stop (STOP) Switch.
INC
+1CAM
G-Seq 01 Stop
Monitor 16
9. Press the Decrement (DEC - 1CAM) Switch to move a
sequence one step backward from the step that was
previously stopped by Stop (STOP) Switch.
G-Seq
Monitor 16
10. Press the Forward Sequence (FORWARD SEQ)
Switch, after pressing the Alternate (ALT) Switch, to
start the Group Sequence from the beginning of the
sequence pattern that was previously stopped by the
Stop (STOP) Switch.
11. To cancel the Group Sequence select a camera.
Refer to the Camera Selection on page 98.
8. Displaying Playback Video
If connected the VTR's Video Output to the Monitor Input
(MONITOR IN) Connector on the WV-PB5504AE Video
Output Board, the VTR's video is displayed on the monitor
by following procedures.
When selected this function, the Camera Title, Data, and
Time are not displayed on the monitor.
1. Select the monitor that is connected to the Monitor
Output (MONITOR OUT) Connector systemized with
the connected VTR's Monitor Input (MONITOR IN)
Connector. Refer to the Monitor Selection on page 98.
2. Press the Alternate (ALT) Switch then press the
Monitor (MON) Key.
The picture on the monitor will be switched to the
video, that is connected on the Video Output Board,
and displayed "in" shown below on the LCD.
ALT
A1
Camera
Monitor 01 [in]
3. Press the Alternate (ALT) Switch again to return to the
original picture.
-105-
DEC
-1CAM
01 Stop
FORWARD
SEQ ALT
1 2 3
4 5 6
7 8 9
0
MON CAM
ESC SET
01
6