Advertisement
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS []
Are these
the right instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the label on the back of the refrigerator--
[]
[]
[] []
[]
[]
[] []
[]
[]
[] [] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
•
CAUTION
-
Unplug
the
_
Refrigerator.
To eliminate
the danger
of electric shock during installation,
you must unplug
the refrigerator
from its electrical
outlet.
[] ATTACH THE WATER VALVE
• Locate the female connector
plug (C).
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
Sharpknife
screwdrivers
1/4" and5/16" Nutddvers
Tape measure
I_REMOVE
THE COVER
At the bottom
rear of the refrigerator,
remove
the
screws holding
the access cover.
Bend the cover back to access the compartment.
Be sure to save the screws as the access cover must
be reinstalled
later to ensure
that )'our refrigerator
will funcdon
properly.
• Plug the female
connector
(C) onto the male
terminals
on the water valve (4). Either
wire
can go on either
terminal.
• Slide the water valve shield with ground wke shipped
with the refrigerator
completely
onto the water valve.
NOTE:
If the water valve shield (part WR02X11753)
has been misplaced
and/or the ground wire (part
WR23X10347)
is missing from the water valve shield,
call 1.800.626.2002
and order the appropriate part(s).
[] CUT PLASTIC WATER TUBING
• Measure 25" (64 cm) of water tubing
starting
from where it is secured to the water valve.
Cut off excess tubing
with a sharp knife or
single-edge
razor blade.
25" (64 crn)
• Fasten the water valve to the cabinet
by driving
the hex-head
screw (13) from the kit into the
hole in the cabinet
leg.
Cabinet
Hex-head
/atervalve
bmcket
6O
Advertisement
