Advertisement
Installation Instructions
r_INSTALL WATER LINE CLAMP
• Attach
the metal water llne damp
(strain relief)
(8) to the refrigerator.
Drive one of the screws,
removed
in Step 1, into the cabinet
edge through
the clamp and hole in compressor
cover.
• The metal clamp
is for the house water line (see
Water Line Installation
Instructions).
It is not to
be used for the tubing
from the water valve up to
the icemaker.
Screw
[_]CONNECT
THE WATER LINE
• Remove the small plastic cap (B) from the bottom
of the water tube inlet located
in the upper-right
rear corner
of the refrigerator.
• Squeeze
the ends of the hose damp
(6) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing
the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately
1" [25 mm]).
• Then
slide the clamp downward
to capture
the
plastic water line in place.
• Make sure the fill robe is aimed down.
Water tube
_-_
[] ATTACH THE PLASTIC WATER LINE
Fasten the Plastic water line to the back of the
cabinet
with adhesive-backed
fasteners
(5),
spacing
the fasteners
as shown to take up the
s]ack in the line.
/k
Adhesive-backed
fasteners
forplastic water l ine
[] WATER VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for
connection
to the home
water supply. After water
line installation
is completed,
set the icemaker
power
switch to I (on).
The icemaking cycle will not be_n until the icemaker
and freezer compartment
reach operating temperature,
then icemaking will begin automatically.
17
Advertisement
