Table of Contents
Advertisement
CHAPTER 1: BEFORE YOU START
Product identification number
D400 SUBSTATION GATEWAY USER'S MANUAL
–
Altera Quartus programmer
–
D400 upgrade manager utility
–
D400 FPGA firmware
•
USB Blaster cable
When ordering upgrade kits with the Dual Ethernet controller, ensure that the existing
D400 unit to be upgraded is equipped with the second network card option.
The D400 comes with an ID number that identifies the supplied options and hardware
configuration of the unit. This ID number is composed of * followed by 6 alphanumeric
characters. The ID number is listed on a label located next to Slot 1 on the rear panel of the
D400.
Figure 2: D400 identification number
Location of ID number label
GENERAL
ORDERING GUIDE
19
Advertisement
Table of Contents
