Emergency Operation; Lone Worker Mode - Kenwood TK - 7160 Instruction Manual

If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
1 Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver, the length of time
you must hold the Emergency key will vary.
• When the transceiver enters Emergency mode, the transceiver will change to the
Emergency channel and begin transmitting based on how the transceiver is set up
by your dealer. Transmit periods are also set by your dealer.
2 To exit Emergency mode, press and hold the Emergency key again.
• If the Emergency mode completes the preset number of cycles, Emergency mode
will automatically end and the transceiver will return to the channel that was in use
before Emergency mode was entered.
Note: Your dealer can set the transceiver to emit tones and received signals as normal or mute the
speaker during Emergency operation.
L W M
ONE ORKER ODE
Lone Worker Mode is a safety feature built into the transceiver. If the transceiver
is not operated for a period of time that exceeds the programmed time, the
transceiver will emit a tone and automatically enter Emergency operation.
The default Lone Worker duration is 10 minutes. Your dealer can set the
duration to last from 1 minute to 60 minutes.
The Lone Worker function can be toggled ON or OFF by pressing and holding
the key programmed as Lone Worker for 2 seconds.
24

EMERGENCY OPERATION