Sharp AR-C260P Key Operator's Manual page 18

Adjusting the colour balance (additional information for Steps 5 through 13 on the previous page)
[Test page (printed by printer)]
Low Density Mid Density
C M Y Bk C M Y
Column 1
Place the colour chart on the test page and
1
compare the colours.
For the placement of the colour chart, see page 15.
In column 1 of the test page, locate the colour
2
density level that is the same as
chart. Mark that level with a pencil or pen to help
you remember it.
If none of the levels in column 1 match
colour chart, do the following:
G
If the density level of
darker than the maximum value (+4) in
column 1, mark "+4" in column 1.
G
If the density level of
lighter than the minimum value (-4) in column
1, mark "-4" in column 1.
Repeat the above step for columns 2 through 12
3
of the test page, comparing each column with the
corresponding colour in the colour chart.
High Density
Bk C M Y Bk
Column 12
Colour density level
in the colour
in the
in the colour chart is
in the colour chart is
DESCRIPTION OF PROGRAMS
[Standard colour chart (included with printer)]
1 2
In Steps 5 through 13 on the previous page,
4
enter the levels that you marked on the test page
(enter each level as a number from -4 to 4).
If you selected "+4" or "-4" for a colour that does
5
not have a density level that matches the level in
the colour chart, repeat the procedure on the
previous page.
12
17