Table of Contents
Advertisement
How to Find Your TV's
Video Input Channel
You need to tune your TV to the Video Input Channel if you are
using the VCR's AUDIO/VIDEO
OUT jacks to connect to the TV's
AUDIO/VIDEO
INPUT jacks. You must select this "channel"
before you can see the VCR's menus, the cable or antenna
reception,
and the content that's on a tape.
The video channel on TVs varies for different
brands and
different
models. Below are some steps to try:
If your TV brand is GE, RCA, or PROSCAN, press the TV
button on the remote control that came with the VCR. Then
press the INPUT button on the remote.
If those options
do not work, try the following
ideas. You might
access the Video Input Channel by:
pressing a button on the TV's remote control (see table
below)
selecting the channel from the TV's menu system
(see table below)
tuning
directly to the channel by selecting
a specific channel
number
(see table below)
going through
all the channels in the channel list by
pressing the channel up or down buttons
on the TV.
Some common
scenarios are listed in the Video Input Channel
Variations
table that follows:
INPUT
Button
TV autton
Video
Input
Channel
Variations
Button/Switch
Button on the
Channel
on the TV
TV Remote
Number
VIDEO
VID 1
00
SIGNAL
LINE
90
VID 1
VID
91
VID 2
VIDEO
92
S-VlD
S-WD
93
S-VIDEO
INPUT
VID 1
S-VIDEO
VID 2
SOURCE
AUX
47
Advertisement
Table of Contents
