Fujitsu PRIMERGY RX200 S2 User Manual page 257

Message
Memory configuration has changed -
Run SETUP
No usable system memory.
Memory module failed! This module
is no longer available for the operating
system.
No usable CPU
Patch for installed CPU not loaded.
Please run the bios flash update
diskette.
CPU disable! CPU is no longer
available for the operating system.
Invalid System Configuration Data
Resource Conflict
IRQ not configured
Expansion ROM not initialized
Allocation error static node #
Baseboard Management Controller
has detected an error
A temperature has exceeded the
warning threshold
A temperature has exceeded the
critical threshold
table: List of POST Error Messages
If this error occurs after addition of memory modules, change [Reset
Configuration Data] on the "8.2.5 Advanced Menu" ( pg.215) to [Yes]
in the BIOS Setup Utility. If the message still appears, contact an office
listed in the "Contact Information" of the "Start Guide".
The memory is abnormal. Refer to the system event log and replace the
abnormal DIMM. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information" of the
"Start Guide".
"7.4 Installing Memory Modules" (pg.174)
Turn the server off and check that the memory modules are installed
properly. If the message appears after the server is turned on again,
check the system event log and replace the memory modules. If the
message still appears, the baseboard must be replaced. Contact an office
listed in the "Contact Information" of the "Start Guide".
The CPU is abnormal. Contact an office listed in the "Contact
Information" of the "Start Guide".
Check that the correct CPUs are installed. If so, update the BIOS. If the
same message appears again, change [Reset Configuration Data] on the
"8.2.5 Advanced Menu" ( pg.215) to [Yes] in the BIOS Setup Utility. If
the message still appears, contact an office listed in the "Contact
Information" of the "Start Guide".
The CPU is abnormal. Contact an office listed in the "Contact
Information" of the "Start Guide".
Change [Reset Configuration Data] on "8.2.5 Advanced Menu"
( pg.215) to [Yes] in the BIOS Setup Utility. If the message still
appears, contact an office listed in the "Contact Information" of the
"Start Guide".
System resources (IRQs, DMA channels, or I/O port addresses) conflict.
Start up the BIOS Setup Utility again and check the system resource
settings.
"8.2 BIOS Setup Utility" (pg.208)
If the message still appears, contact an office listed in the "Contact
Information" of the "Start Guide".
Check the settings on the BIOS Setup Utility. If the message still
appears, replace the expansion card. If the message still appears, contact
an office listed in the "Contact Information" of the "Start Guide".
On the screen, check the expansion card or device being initialized.
Replace the card. If the message still appears, contact an office listed in
the "Contact Information" of the "Start Guide".
An onboard device or expansion card is abnormal. Replace the device or
expansion card. If the message still appears, contact an office listed in
the "Contact Information" of the "Start Guide".
Check the system event log and replace the abnormal option.
Temperature is abnormal.
Check and improve the environment. If the message still appears,
contact an office listed in the "Contact Information" of the "Start Guide".
PRIMERGY RX200 S2 User's Guide
Description
9
257