Getting Started; Beforesettingovencontrols - Electrolux 30" Gas Range Use & Care Manual

Getting Starte
BEFORESETTINGOVENCONTROLS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Oven Vent Location
The oven is vented through the back-
guard. When the oven is on, warm air is
released through the vent. This venting
is necessary for proper air circulation in
the oven and good baking results.
Oven Rack
Oven vent
Removing and Replacing Oven
Racks
ALWAYS ARRANGE OVEN
RACKS WHEN THE OVEN IS COOL
(PRIOR TO OPERATING THE
OVEN). Always use oven mitts when
using the oven.
To remove an oven rack, pull the
rack forward. Lift up the rack off the
oven rack slider. To replace an oven
rack, place the rack on the slider into
the 4 pinholes located at the 4 corners
of the rack.
installing Oven Rack Supports
ALWAYS INSTALL OVEN RACK SUPPORT BEFORE
TURNING ON THE OVEN (WHEN THE OVEN IS COOL).
To remove the oven rack supports for a self-clean cycle,
pull up the support from the oven rack support brackets to
disengage supports from the oven. If the rack supports are not i
removed, the self-clean cycle won't start. Always remove the
left side support first. To install oven rack supports insert the
rack supports into the rack support brackets on the oven side
as shown.
i
_ _I Toremove
_ fro.,
shders
To place on
i Pull oven rack forward and sliders
lift it up of the oven rack
slider.
Removing Non-Sliding Oven Racks
Simply pull the rack and slightly tilt it upward when the rack hits its stop position.
Replacing Non-Sliding Oven Racks
Insert the rack into the oven rack supports by inserting the rack openings into the rack sup-
_orts. Be sure the rack is at the same position on each oven rack support on both sides.
to-o o o o o o o o.o_o o,,orr o o o o o o o "o_
u i J
..... ,nserttheopenin0s
into the rack support
Always arrange the oven racks when the oven is cool (prior to operating the oven). Always use
oven mitts when using the oven.