Related Manuals for Miele ESW 408x-14
Summary of Contents for Miele ESW 408x-14
- Page 1 Operating and Installation Instructions Built-in Warming Drawer ESW 408x-14 ESW 47xx ESW 48xx en - US, CA To prevent accidents and machine damages, read these instructions before installation or use. M.-Nr. 07 342 380...
-
Page 2: Table Of Contents
Contents IMPORTANT SAFETY INSTRUCTIONS....... . . 3 Guide to the warming drawer ........7 ESW 408x-14 . -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Correct usage WARNING- When using your This appliance is not designed for appliance follow basic precautions, commercial use. It is intended for use in including the following: domestic households and in similar working and residential environments Read all instructions before such as: installation or use to prevent injury and appliance damage. - Page 4 Tampering with electrical connections or components and mechanical parts is dangerous and could cause machine damage. Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty.
- Page 5 IMPORTANT SAFETY INSTRUCTIONS Safety Do not heat unopened food containers. Pressure can build up Protect your hands with oven mitts causing an explosion that will damage or potholders when using the the cooking compartment. There is also appliance. Use only dry, heat resistant a danger of personal injury and potholders.
- Page 6 IMPORTANT SAFETY INSTRUCTIONS The use of accessories not recommended by Miele may cause injury. Make certain that the power cords of small appliances do not come in contact with the appliance. The insulation of the cable could become damaged. Danger of electric shock! Do not lean, sit or overload the warming drawer.
-
Page 7: Guide To The Warming Drawer
Guide to the warming drawer ESW 408x-14 a Control panel b Non-slip mat... -
Page 8: Esw 47Xx / Esw 48Xx
Guide to the warming drawer ESW 47xx / ESW 48xx a Control panel b Non-slip mat c Vent d Rack... -
Page 9: Control Panel
Guide to the warming drawer Control panel On/Off Temp. Turns the warming drawer On and Off Allows you to select the desired temperature. Menu Allows you to select the operating The display shows: mode ] ^ ^ ^ ^ Operating modes: See "Temperature settings"... -
Page 10: Before The First Use
Before the first use Heat the appliance When first connecting the appliance to the power supply and after a power Heat the warming drawer for a failure, the fan will run and a display minimum of 2 hours. test will be carried out for ^ Turn on with the "On/Off"... -
Page 11: Using The Warming Drawer
Using the warming drawer Operating modes Tap the "Menu" touch control until the desired operating mode lights: – / Cups/Glasses – H Tableware – 2 Food - warm and hold The last operating mode selected appears in the control panel when the drawer is turned on. -
Page 12: Temperature Settings
Using the warming drawer Temperature settings Each operating mode has an assigned temperature range. The suggested temperatures are set by default, they are marked in bold in the table below. Use the "Temp." touch control to change the setting in increments. The last selected temperature is shown in the control panel the next time the warming drawer is turned on. -
Page 13: Duration
Using the warming drawer Duration Operation ^ Open the drawer. The warming drawer is set for continuous operation by default. By ^ Turn the appliance on with the selecting the "Timer" touch control a "On/Off" touch control. warming time can be set. With each tap ^ Select "Menu"... -
Page 14: Sabbath Mode
Using the warming drawer Sabbath Mode Activate ^ Press and hold "Timer". For religious observance, the appliance can be set for the duration of the ^ At the same time press and hold Sabbath. In Sabbath mode the timer is "On/Off". -
Page 15: Loading The Warming Drawer
The maximum load is 55 lbs (25 kg). Do not overload the drawer. To increase the load space use the supplied rack. Two racks will fit in the drawer at one time. Additional racks are available from Miele. ESW 408x-14 ESW 47xx / ESW 48xx... -
Page 16: Keeping Food Warm
Keeping food warm Tips The warming drawer is intended for keeping food warm directly after preparation. It is not intended to re-warm cold meals. – To ensure that the minimum temperature of 150°F (65°C) required to keep food warm is met, select 2. –... - Page 17 Keeping food warm Settings Food Type of Lid on Temperature for Position in 2 setting container container drawer Floor Rack* ^ ^ ] ^ ^ Bacon Plate ] ^ ^ ^ ^ Beef** Rare / Medium / Well ^ ^ ^ ^ ] Bread hard rolls Plate ^ ^ ^ ^ ]...
-
Page 18: Warming Tableware
Warming tableware Tips Warming times – Distribute tableware throughout the Various factors will affect the warming entire drawer. Stacked plated will times of tableware: heat up more slowly than individual – type and thickness of the dishes, pieces. If stacking is unavoidable –... -
Page 19: Other Usages
Other usages The warming drawer can also be used to proof yeast dough or to warm or crisp bread. Proofing dough Warming/Crisping bread ^ Open the drawer. ^ Open the drawer. ^ Turn the appliance on "On/Off". ^ Turn the appliance on "On/Off". ^ Touch "Menu"... -
Page 20: Cleaning And Care
Cleaning and care Allow the appliance to cool before Glass cleaners may be used to cleaning. clean the exterior. However do not allow them to sit or "puddle", this can Do not use a steam cleaner to clean cause damage to the surface. this appliance. -
Page 21: Frequently Asked Questions
Frequently asked questions Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. What if the drawer does not heat? Possible fault Solution There is no power to the warming Insert the plug into the outlet. -
Page 22: Technical Service
Miele appliance. Please note that unless expressly approved in writing by the Miele Ser- vice department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. -
Page 23: Installation Instructions
Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information. To prevent accidents and machine damage read these instructions before installation or use. -
Page 24: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Before installation make sure that ESW 408x-14 the voltage and frequency listed on the Only install the warming drawer in data plate correspond with the combination with built-in appliances household electrical supply. This data recommended by the manufacturer. must correspond in order to avoid risk When installed with other appliances, of damage to the appliance. -
Page 25: Esw 408X-14
ESW 408x-14 Miele appliances can be installed flush or proud. Discuss your installation requirements with your architect, designer and installer. Combination possibilities Installation with an oven ( 3 0 m ( 2 2 * / 2 3 * * m m... - Page 26 ESW 408x-14 Installation with a speed oven ( 2 2 * / 2 3 * * m m ( 5 4 0 ( 5 ( 5 6 ( 5 6 - 5 6 * Machine with glass front ** Machine with stainless steel front...
- Page 27 ESW 408x-14 Installation with a steam oven ( 2 2 * / 2 3 * * m ( 4 4 0 ( 5 ( 5 4 ( 5 6 - 5 6 * Machine with glass front ** Machine with stainless steel front...
- Page 28 ESW 408x-14 Installation with a coffee machine ( 2 0 ( 4 6 0 ( 5 ( 5 5 ( 5 6 * / 2 * * ) * Machine with glass front ** Machine with stainless steel front...
-
Page 29: Esw 408X-14 Brws
ESW 408x-14 BRWS Combination possibilities Installation with an oven ( 3 0 m ( 2 2 * / 2 3 * * m m ( 5 4 8 ( 5 4 0 ( 5 ( 5 6 a Cut-out for venting the oven * Machine with glass front ** Machine with stainless steel front... - Page 30 ESW 408x-14 BRWS Installation with a speed oven ( 2 2 * / 2 3 * * m m ( 5 4 0 ( 5 ( 5 6 ( 5 6 - 5 6 * Machine with glass front ** Machine with stainless steel front...
- Page 31 ESW 408x-14 BRWS Installation with a steam oven ( 2 2 * / 2 3 * * m ( 4 4 0 ( 5 ( 5 4 ( 5 6 - 5 6 * Machine with glass front ** Machine with stainless steel front...
- Page 32 ESW 408x-14 BRWS Installation with a coffee machine ( 2 0 ( 4 6 0 ( 5 ( 5 5 ( 5 6 * / 2 * * ) * Machine with glass front ** Machine with stainless steel front...
-
Page 33: Esw 47Xx
ESW 47xx Solo installation Side view a A base is required for solo installations... - Page 34 ESW 47xx Installation with an oven Side view with oven...
-
Page 35: Esw 48Xx
ESW 48xx Solo installation Side view a A base is required for solo installations... - Page 36 ESW 48xx Installation with an oven Side view with oven...
-
Page 37: Installation
Installation Miele appliances can be installed flush or proud. Discuss your installation requirements with your architect, designer and installer. Check that the base of the warming drawer is clean and level. Only then will it function properly. When inserting the appliance, wear work gloves to avoid injuries. -
Page 38: Aligning The Appliance Front
Installation Aligning the appliance front After installation it may be necessary to align the appliance front and/or the gap between the appliances/furniture front above. ^ Remove the screws a from the left and right sides of the drawer front. ^ Carefully lift the control panel out of the drawer. Be careful not to pull or damage the power cord. - Page 39 Installation ^ Loosen the 2 screws b on the inside of the drawer front. ^ Align the front. ^ Tighten the screws on the inside of the drawer front. ^ Replace the control panel, use caution with the power cord. ^ Replace the screws on the left and right sides of the drawer front.
-
Page 40: Integrated Installations
Installation Integrated installations Custom made front panels can be installed with models ESW 4702 FB and ESW 4802 FB. The custom panel must be at least " (19 mm) thick and made of heat resistant material 140 °F (60 °C). The front panel, including handle, must not exceed 11 lb (5 kg) in weight. - Page 41 Installation ^ Remove the cable tie from the panel. ^ Screw the removed panel to the custom panel (see illustration). ^ Hook the panel into the bottom. Make sure the seal is seated correctly. ^ Replace and slightly tighten the screws on the inside of the drawer front.
-
Page 42: Electrical Connection
Electrical connection Power supply CAUTION: Before servicing, This appliance is equipped with a 5 ft disconnect the power supply by (1.5 m) long power cord with a either removing the fuse, shutting off three-prong grounding plug ready for the power main or manually connection to a 120 V, 15 A, 60 Hz "tripping"... -
Page 43: Help Protect Our Environment
Help protect our environment Disposal of packing materials Disposal of an old appliance The cardboard box and packing Old appliances contain materials that materials are biodegradable and can be recycled. Please contact your recyclable. Please recycle. local recycling authority about the possibility of recycling these materials. - Page 44 Alteration rights reserved / 4611 M.-Nr. 07 342 380 / 08 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.