Ec4: Ags Current Sensor Faulty Error; Ef1: Drain Hose Blocked/Kinked/Too High; Drain Filter Clogged/Dirty; Ef2: Excessive Detergent Dosing; Drain Hose Kinked/Blocked; Drain Filter Dirty/Clogged; Ef3: Aqua Control Device Triggered - Electrolux 6 Series Service Manual

Hide thumbs Also See for 6 Series:

Service manual (84 pages)

Service manual (66 pages)

Service manual (76 pages)

Table Of Contents

Table of Contents

Guide to diagnostics of NEW COLLECTION EWM09312 electronic controls

EC4

Replace the main circuit board and run the diagnostic cycle to check for any further alarms.

EF1

EF1: Drain hose blocked/kinked/too high; drain filter clogged/dirty

This warning only appears at the end of the cycle. The appliance detected long drainage phases during

the cycle. (E.g.: More than 20 seconds when draining after rinses). Check/clean the drain filter.

EF2: Excessive detergent dosing; drain hose kinked/blocked;

EF2

This is an excessive detergent dosing warning. The system detected too much foam was forming

during the drain phases. Advise the Customer to use the correct quantity of detergent and to make sure

EF3

This warns about the presence of water at the bottom of the appliance. Check for any water leaks

Or caused by excessive overheating of the drain pump. Check for any items which may obstruct

EF4: Water pressure too low, no signal from flowmeter, with

EF4

This warning is for the water pressure which is too

If the water pressure is connect, check: the wiring of the flowmeter and the Flowmeter.

EF5

This is an unbalanced load warning. The appliance detected an extremely unbalanced load during the

spin phases. Advise the customer to load more washing into the drum and not just individual garments.

EF6

No action to be performed; if it continues, replace the main circuit board.

T.S.-mdm FCPD-dp Quality tb