Table of Contents
Advertisement
Right Motion Control Linkage Shown
1. Upper jam nut
2. Jam nuts
7.
Retighten the jam nuts on the control rod.
8.
Replace the knee pad.
Motion Control Tracking
Adjustment
If the machine travels or pulls to one side when the
motion control levers are in the full forward position,
adjust the tracking.
1.
Park the machine on a level surface.
2.
Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
3.
Make sure there is a 95 mm (3.75 inches) gap
between the motion control levers and the front
reference/speed control bar. Refer to
Control Linkage Adjustment (page
4.
Remove the knee pad.
5.
Loosen the top jam nut at the upper end of the
ball joint on the lever that needs to be adjusted
(Figure
45).
6.
To increase the speed, turn the control rod
counterclockwise in quarter turn increments. To
decrease the speed, turn the control linkage
clockwise in quarter turn increments.
7.
Retighten the jam nuts on the control rod.
8.
Drive the machine and check the full forward
tracking.
Figure 45
3. Control rod
Motion
51).
9.
Replace the knee pad.
10.
Repeat steps
is obtained.
g387366
52
5
through
8
until desired tracking
Advertisement
Table of Contents
