Raising And Lowering Attachments; Positioning The Seat - Toro Wheel Horse 520xi Operator's Manual

forward and will not operate in reverse. To correct this
situation, move the cruise control switch to the off
position or press the brake pedal to disengage the cruise
control.
Disengaging the Cruise Control
To disengage the cruise control, complete one of the
following steps:
While holding your foot steady on the traction control,
move the cruise control switch to the off position
(Fig. 18).
Press the brake pedal.
This automatically disengages the cruise control and
applies the brake at the same time.
Raising and Lowering
Attachments
Raise and lower attachments using the attachment power
lift lever. This lever is located to the right of the steering
wheel (Fig. 19).
Figure 19
1. Attachment power lift lever
Raising Attachments
1. Start the tractor.
2. Pull the lift lever up to raise the attachment (Fig. 20).
1. Lift lever, Up
3. Release the lever when the attachment has reached the
desired height.
The attachment will remain in the raised position until
you lower it again.
When the engine is off, attachments in the raised
position may gradually lower, possibly pinning or
injuring you or a bystander.
Lower the attachment lift before stopping the
1
engine.
Lowering Attachments
1. Start the tractor.
2. Push the lift lever down to lower the attachment
(Fig. 20).

Positioning the Seat

You can move the seat forward and backward. Position the
m–3258
seat where you have the best control of the machine and
are most comfortable.
1. Move the adjustment lever sideways to unlock seat
(Fig. 21).
2. Slide the seat to the desired position and release the
lever to lock the seat into position.
Important
before operating.
18
1
Figure 20
2. Lift lever, Down
Warning
Ensure that the seat is locked in position
2
m–3315